IBM Deskstar Deskstar 3, User Manual

Page: 211 / 392

3. Lift the forms guide to its full open (vertical) position.
Forms Guide
Push-Pull Selector
4. Determine which tractor installation steps to follow:
v
If you are installing a tractor not currently installed in a printer, go to step 5
on page 203
v
If you are installing a tractor currently installed in a Front Push position, go
to step 4d on page 202.
v
If you are installing a tractor currently installed in a Rear Pull position,
continue here.
a. Grip both sides of the round tractor shaft while operating the tractor
release levers as shown. Lift the tractor out of the printer.
T r a c t o r R e l e a s e L e v e r s
R o u n d T r a c t o r S h a f t
b.
Place the tractor face down on a flat surface with the electrical connector
tab on the right side, pointing toward you.
c. Pull the bottom release levers toward you with your finger tips and push
the movable edge of the tractor down toward the flat surface with your
Chapter 17. Setting Up Forms Paths
201