IBM Deskstar Deskstar 3, User Manual

Page: 315 / 392

055 MACHINE CHECK X Y Z
SEE USER’S GUIDE
056 MACHINE CHECK X Y Z
SEE USER’S GUIDE
A firmware error has occurred. Record the error information X, Y, Z.
Recovery:
1.
Power off (O) the printer.
2.
Wait 10 seconds, then power on (|) the printer.
3.
If the printer displays this status code again, call for service.
059 CANCEL PRINT ACTIVE
This is an informational message. The printer displays this message after you press
Cancel Print
.
Recovery:
1.
Press Start to cancel the current print job or press Cancel Print again (before
pressing Start) to return the printer to ready. (The print job will not be
canceled.)
060 BUFFER REPRINT ACTIVE
This is an informational message. The printer displays this message after the Buffer
Reprint Code is sent and accepted. See Chapter 14, “Send Buffer Reprint Code
(Coax)”.
Recovery:
1.
Press Start. The buffer reprints. The message will change after the buffer has
finished reprinting.
061 PA1 SELECTED
062 PA2 SELECTED
These are informational messages. The printer displays these messages after you
press PA1 or PA2.
Recovery:
1. Press Start. The status code disappears when the controller accepts the input.
063 PRINTER IN SEND STATE
Chapter 20. Problems
305