IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 95 / 164

Note: See “System” on page 94 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
175
(Hardware error)
v System board
184
(Power-on password damaged)
1. Run the Configuration/Setup Utility program.
2. System board.
187
(VPD serial number not set.)
1. Set serial number in the Configuration/Setup Utility program.
2. System board.
188
(Bad EEPROM CRC #2)
1. Run the Configuration/Setup Utility program.
2. System board.
189
(An attempt was made to access the
server with invalid passwords)
v
Run the Configuration/Setup Utility program, and enter the
administrator password.
201
(Memory test error.) If the server does not
have the latest level of BIOS installed,
update the BIOS to the latest level and
run the diagnostic program again.
1. DIMM
2. System board
289
(DIMM disabled by POST or user)
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
3. System board
301
(Keyboard or keyboard controller error)
1. Keyboard
2. System board
303
(Keyboard controller error)
v
System board
602
(Invalid diskette boot record)
1. Diskette
2. Diskette drive
3. Cable
4. System board
662
(Diskette drive configuration error)
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
962
(Parallel port error)
1. Disconnect the external cable on the parallel port.
2. Run the Configuration/Setup Utility program.
3. System board.
1162
(Serial port configuration conflicts)
1. Run the Configuration/Setup Utility program and ensure that the
IRQ and I/O port assignments needed by the serial port are
available.
2. If all interrupts are being used by adapters, remove an adapter or
force other adapters to share an interrupt.
Chapter 7. Symptom-to-FRU index
85