IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 81 / 164

Heat-sink
retainer bracket
screws (4 places)
Heat-sink
retainer bracket
screws (4 places)
System board
screws (7 places)
Locator pin
I/O port
screws (4 places)
Locator
hole
15. Remove the six I/O port screws at the rear of the server.
16. Remove the eight screws that secure the two heat-sink retention modules to
the system board. These eight screws also secure the system board to the
chassis.
17. Remove the remaining seven screws on the system board that secure the
system board to the chassis.
18. Carefully pull the board out of the server, taking special care not to disturb any
surrounding components.
To reinstall the board, place it carefully into position and ensure the locator pin
engages the locator hole in the system board.
Reverse steps 5 on page 70 through 14 on page 70 to replace the components that
were removed.
Note: When reassembling the components in the server, be sure to route all cables
carefully so that they are not exposed to excessive pressure.
Chapter 6. Service replaceable units
71