IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 66 / 164

Power supply
Note:
v
Read “Installation guidelines” on page 25.
v
Read the safety notices at “Safety information” on page 101.
Complete the following steps to remove the non-hot-swap power supply.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do
not turn off the electrical current supplied to the device. The device also might have
more than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
1
2
1. Turn off the server and all attached peripheral devices.
2. Disconnect all power cords and external cables from the back of the server.
3. Remove the server from the rack; then, remove the server cover (see
“Removing the cover and bezel” on page 27) and take out the air baffle.
4. Remove the power-cord module.
56
Eserver
325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide