IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 13 / 164

Features and specifications
The following table provides a summary of the features and specifications of your
Eserver
325 Type 8835 server. Depending on your server model, some features
might not be available, or some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
v
AMD Opteron
™
200 Series Processor
(one to two-way)
– Minimum: One
– Maximum: Two
v 1024 KB Level-2 cache
Note: Use the Configuration/Setup Utility
program to determine the type and speed
of the microprocessors in your server.
Memory:
v AMD HyperTransport
™
technology
v Type: Error correcting code (ECC),
double-data rate (DDR) SDRAM,
registered DIMMs with Chipkill
™
memory protection
– Minimum: 1 GB
– Maximum: 6 GB (12 GB with
availability of 2 GB DIMMs)
– Installable in pairs
v
Four interleaved slots with standard
microprocessor
v Two interleaved slots with optional
microprocessor
Drives:
v
CD-ROM: slim IDE (standard)
v Hard disk drives
– Slim-high 3.5-inch drives, hot-swap
SCSI or non-hot-swap IDE (drive
capacity and speed vary with
model)
– Maximum: Two
Expansion slots:
v One full-length adapter slot supports
up to 100 MHz/64-bit PCI-X adapters
(bus 3)
v
One half-length adapter slot supports
up to 100 MHz/64-bit PCI-X adapters
(bus 3)
v
Supports 3.3 V or universal adapters
only
Video controller:
v
ATI RageXL video controller integrated
on system board
v Compatible with SVGA
v
8 MB SDRAM video memory
Power supply:
One 411 watt (115-230 V ac)
Size:
v Height 43 mm (1.69 in.)
v
Depth: 660 mm (25.98 in.)
v Width: 440 mm (17.32 in.)
v Weight: approximately 12.7 kg (28 lb)
when fully configured
Integrated functions:
v Baseboard management controller
v
One single-channel LSI Ultra320 SCSI
controller
v Two Broadcom 10/100/1000 Ethernet
controllers (dual-port design) with Wake
on LAN
®
v
Four Universal Serial Bus (USB) ports
v One serial port
v
One video port
Acoustical noise emissions:
v Declared sound power, idling: 6.5 bels
v
Declared sound power, operating: 6.5
bels
Environment:
v
Air temperature:
– Server on: 10° to 35°C (50.0° to
95.0°F). Altitude: 0 to 914 m (2998.7
ft)
– Server on: 10° to 32°C (50.0° to
89.6°F). Altitude: 914 m (2998.7 ft) to
2133 m (6998.0 ft.)
– Server off: 10° to 43°C (50.0° to
109.4°F). Maximum altitude: 2133 m
(6998.0 ft)
v
Humidity:
– Server on: 8% to 80%
– Server off: 8% to 80%
v Airflow rates:
– Minimum: 28 CFM
– Maximum: 47 CFM
Heat output:
Approximate heat output in British thermal
units (Btu) per hour for dual multiprocessor
configurations:
v Minimum configuration: 789 Btu (230
watts)
v
Maximum configuration: 1619 Btu (472
watts)
Electrical input:
v
Sine-wave input (50-60 Hz) required
v
Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v
Input kilovolt-amperes (kVA),
approximately:
– Minimum: 0.12 kVA
– Maximum: 0.40 kVA
Notes:
1. Power consumption and heat output vary
depending on the number and type of
optional features installed and the
power-management optional features in
use.
2. These levels were measured in controlled
acoustical environments according to the
procedures specified by the American
National Standards Institute (ANSI)
S12.10 and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given location
might exceed the average values stated
because of room reflections and other
nearby noise sources. The declared
sound-power levels indicate an upper
limit, below which a large number of
computers will operate.
Chapter 1. General information
3