IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 69 / 164

CD-ROM drive
Complete the following steps to remove the CD-ROM drive.
Note:
v
Read “Installation guidelines” on page 25.
v
Read the safety notices at “Safety information” on page 101.
v
Read “Handling static-sensitive devices” on page 25.
1. Turn off the server and all attached devices.
2. Disconnect all power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the server cover (see “Removing the cover and bezel” on page 27);
then, take out the air baffle.
5. Remove the four microprocessor fans, making note of their orientation for later
replacement.
6. Disconnect the CD-ROM drive power cable from the system board.
7. Disconnect the IDE cable from the CD-ROM drive.
8. Press the release cam until the media tray protrudes slightly from the front of
the server.
Note: The illustrations in this publication might differ slightly from your
hardware.
Release cam
Media tray
CD-ROM
disk drive
Interposer
card
Retainer wire
Holes
Retention tab
9. Carefully pull the drive assembly out of the chassis.
10. Remove the retaining wires on the drive assembly.
11. To remove the CD-ROM drive from the media tray, pull gently on the drive and
slide it out of the tray.
12. To remove the interposer card, remove the screw that secures it to the media
tray and pull the card away from the media tray.
To replace the CD-ROM drive, reverse the previous steps.
Chapter 6. Service replaceable units
59