IBM 8835 - Eserver 325 - 1 GB RAM, Maintenance And Troubleshooting Manual

Page: 42 / 164

5. On the rear panel, press the expansion-slot clip together to unlock the clip;
then, pull the clip out from the server until it stops and rotate the clip as shown
in the following illustration. It remains loosely attached to the server.
Power-cord
module
Adapter
retention
bracket
Expansion-
slot clip (adapter slot 1)
Expansion-
slot clip (adapter slot 2)
Retention clip
Alignment tab
Attention: Avoid touching the components and gold-edge connectors on the
adapter. Ensure that the adapter is completely and correctly seated in the slot.
Incomplete insertion might cause damage to the system board or to the
adapter.
6. Remove the expansion slot cover from the slot.
7. To gain access to PCI-X slot 1, remove the PCI riser card from its connector
(see “Riser card” on page 61).
System board
Riser card
8. To gain access to PCI-X slot 2, remove the power-cord module.
a. Press down on the retention clip at the front of the power-cord module and
slide the module toward the front of the server until the alignment tab is
free of the slot on the side of the server.
32
Eserver
325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide