IBM 6400-D Generation II Series, Setup Manual

Page: 94 / 184

94
Chapter 4
Quick Setup Menu
Save Current Values
This option allows you to save up to eight configurations to meet different print
job requirements. This eliminates the need to change the parameter settings
for each new job. The configurations are stored in memory and will not be lost
if you turn off the printer. If the Protect Configs. parameter is enabled, the new
configuration will not be saved unless the existing configuration has been
deleted first. The factory default configuration cannot be changed. See
“Saving Your Configuration In A Custom Set” on page 84 for details.
Change Power On Set
You can specify which of the nine configurations (Factory or 1-8) will be the
power-up configuration.
DBCS to ASCII
This option specifies the operating mode of the Hanzi printer. Refer to “Print
Attributes” in the
LQ1600K Programmer’s Reference Manual for more
information.
NOTE: Available for the Hanzi LP+ printers only.
Print Quality
Sets the print quality of the printer. This key requires confirmation with the
ENTER key.
NOTE: The factory default for the Hanzi LP+ is Near LQ. The factory default
for the Hangul LP+ is LQ.
High Density
High Density enabled will allow the LQ typeface to print in higher print density.
It will not take effect when other typefaces are selected.
Characters Per Inch
Defines the default values for horizontal character spacing. The number of
characters per inch can be selected from 10.0, 12.0, 13.3, 15.0, 17.1, or 20.0.
NOTE: The option is available for the Hanzi LP+ printer only.
DBCS CPI
Defines the default values for horizontal character spacing in DBCS mode.
For the Hanzi LP+ printer, select 5.0, 6.0, 6.7, 7.5, and Other CPI. For the
Hangul LP+ printer, selected from 5.0, 6.0, 6.7, 7.5, 8.5, 10, and other CPI.
NOTE: The factory default for the Hanzi LP+ printer is 6.7 cpi. The factory
default for the Hangul LP+ printer is 6.0 cpi.
Lines Per Inch
Defines the default values for vertical character spacing. The number of lines
per inch can be 6.0, 8.0, 10.3, 3.0, or 4.0.