IBM 6400-D Generation II Series, Setup Manual

Page: 138 / 184

138
Chapter 6
Fault Messages
012 STRUCTURED FLD ERROR No Applications software
has violated structured
data field parameters. Contact your system
administrator.
021 BUFFER OVER
VERIFY CONFIGURATION Yes Receive overrun.
(Serial interface) Check printer serial
port configuration
setup. Ensure that baud
rate matches both host
and printer settings.
024 SERIAL PARITY ERROR Yes Parity error. (Serial
interface) Check printer serial
port configuration
setup. Ensure that
parity setting matches
both host and printer
settings.
025 SERIAL FRAMING ERROR
VERIFY CONFIGURATION Yes Framing error. (Serial
interface) Check printer serial
port configuration
setup. Ensure that it
matches host setting.
026 HEX DUMP MODE N/A Printer attach status
message. No action necessary.
029 8344 DIAGNOSTIC FAILED No Link-level code test
detects hardware
failure. Contact IBM service.
031 END OF FORMS TIMEOUT
LOAD FORMS Yes A timeout message is
sent to the host if
paper is not loaded 10
minutes after Stop was
pressed to clear the
paper out fault. Load paper. See
Operator’s Guide for
procedure.
032 FORMS JAMMED TIMEOUT
CLEAR AND RELOAD FORMS Yes A timeout message is
sent to the host if no
paper motion has
occurred for 10
minutes after Stop was
pressed to clear the
jam fault. Clear paper jam and
reload paper. See
Operator’s Guide for
procedure.
034 RIBBON STALL TIMEOUT
CHECK RIBBON Yes A timeout message is
sent to the host if no
ribbon movement has
occurred for 5 seconds
if Stop was not pressed
to clear the fault. Make sure the ribbon is
not twisted and the
forms thickness lever is
set to match thickness
of media being used. If
fault reoccurs, contact
IBM service.
041 BUFFER OVERFLOW Yes Host sends data after
the printer buffer is full.
(Serial interface.) Check printer serial
port configuration
setup. Ensure that the
Data Terminal Ready
setting matches both
host and printer
settings.
Fault
Message
Operator
Correctable?
Explanation Solution