IBM 6400-D Generation II Series, Setup Manual

Page: 43 / 184

Pedestal Models
43
Pedestal Models
1. Verify that the voltage source at the printer site conforms to the
requirements specified on page 19. Make sure that the printer power
switch is set to Off. (See Figure 20.)
2. Open the box containing the power cord, printer ribbon, and operator
panel overlay label. Refer to Appendix A, “Printer Specifications,” for
recommended cables.
3. Referring to Figure 28 and Figure 29, connect the (customer-supplied)
interface cable from the host computer to the appropriate printer interface
connector:
a. Remove the cover from the I/O connector(s) you have selected.
b. Attach the cable connector to the printer interface connector.
4. Plug the power cord into the printer AC power connector, then into the AC
power outlet (see Figure 30).
<1> Before powering on the printer ensure the printer is plugged
into an appropriate power source. Refer to Chapter 2 of the
Setup Guide for information on the proper source.
<4> Do not connect or disconnect any communication port,
teleport, attachment connector, or power cord during an
electrical storm.
<5> Power off the printer and disconnect the power cord before
connecting or disconnecting any communication port,
teleport, or attachment cable connector.
DANGER:
Connect The Interface And Power Cables