IBM 6400-D Generation II Series, Setup Manual

Page: 103 / 184

Save Current Values
103
Custom/Preloaded Sets 5-8 contain configuration sets that assist with the
installation and configuration of this printer. These sets are preloaded at the
factory. If these sets are not used, you can delete them and create new
custom sets.
Save Current Values
This option allows you to save your custom sets to meet different print job
requirements. This eliminates the need to change the parameter settings for
each new job.
The custom sets are stored in NVRAM—they will not be lost if you power off
the printer.
Factory default is a factory–preset custom set; it cannot be changed or saved.
IMPORTANT
A new custom set will overwrite an existing custom set if the PROTECT
CUSTOM SETS parameter is disabled (e.g., a new Custom Set 4 will
overwrite an existing Custom Set 4). See the “Protect Custom Sets” in
this section.
Delete Custom Set
You can delete one or all of your customized or preloaded custom sets.
Factory default is a factory–preset custom set and cannot be changed or
deleted.
Change Power On Set
You can specify which of the custom sets will be the power-on set. The printer
will power on with the factory set values or with one of the customized
configurations.
Protect Custom Sets
The PROTECT CUSTOM SETS option specifies whether or not a new
custom set can overwrite an existing custom set when you activate the SAVE
CURRENT VALUES parameter.
•
DISABLE (the default) turns protection off, allowing you to overwrite
existing custom sets.
•
ENABLE turns protection on, preventing you from overwriting existing
custom sets. If you attempt to save to an existing set, the following
operator panel message appears:
043 CUSTOM SET EXISTS
You must delete the existing set before trying to save the new custom set.