Adjustment Manual
46
GK DIVIDED PICKUP
Cautions for use
Adjusting the sensitivity
In order to play the [GR] from a GK pickup, you must adjust the input sensitivity of the [GR]. This adjustment is extremely impor-
tant in order to take full advantage of the excellent tracking of the [GR].
For details on this adjustment, read this owner's manual, and then read the [GR] owner's manual.
Setting the output mode
The RG1520G can independently output the signal of the magnetic pickup and the GK signal. Before use, make the output
setting that is appropriate for your situation.
Special cable
You must use a special Roland C-13A (5 m) or C-13B (10 m) cable to make connections to the [GR]. Never use any other cable,
since doing so may cause malfunctions.
The special cable is a locking design. Release the lock mechanism before you attempt to disconnect the cable. Do not pull on
the cable with excessive force.
When performing, you must pass the special cable through your guitar strap near the end pin. If you fail to do so, excessive
strain will be placed on the cable, and this could even damage your guitar.
Other cautions
You must make connections to the [GR] while the [GR] is powered-off. For details on operation, refer to the owner's manuals for
the Roland GR Guitar Synthesizer and V-GUITAR System.
Parts and fheir function
A. Pickup selector
B. Magnetic pickup volume
C. Magnetic pickup tone
D. Synth volume (GK volume)
E. DOWN/S1, UP/S2 switches
You cannot use the DOWN/S1 and UP/S2 switches simultane-
ously.
F. Select switch
This is available only when outputting a signal from the GK
connector.
The select switch does not control the signal of the magnetic
pickup output.
G. Magnetic pickup output jack
When using the magnetic pickup output jack, set the output
mode switch OFF.
H. GK connector
I. GK pickup (piezo pickup)
J. Output mode switch
To change the setting of this switch, detach the control cavity
plate of the guitar and set the switch.
When this is ON, the magnetic pickup signal will simultane-
ously be output from the GK connector.
When this is OFF, the magnetic pickup signal will not be output
from the GK connector. Select the OFF setting if you want to
output the magnetic pickup signal and the GK signal to sepa-
rate devices, or if you want to use only the magnetic pickup.
*
*
*
*
*
*
Fig. 67
Fig. 68
Fig. 67
Fig. 68
PrestageManual.indb 46
10/12/2007 3:50:41 PM