PUMP CORD INSTALLATION
The equipment system has been provided with a pump power cord and liquid-tight
conduit assembly. This is to be used on the main 2-speed pump supplied with the
system. Any other components or accessories attached to the equipment system
should be attached in a similar manner.
Follow the simple instructions below to quickly attach the cord assy to the pump:
Cord Assy included for Pump 1
1) Remove the terminal cover off the
back off the pump
2) Remove the conduit hole cover
3) Route the power wires through the conduit hole and pull
toward you to allow for the cord assy to be rotated for tightening.
4) While holding the wires as shown
thread the liquid-tight connector into the
pump until secure then connect the
power wires to the pump per the label
on the pump.
5) Route the other end of the conduit
through the empty knock-out and secure
with lock-nut. The cord inside will route
up to the terminal strip inside the upper
portion of the enclosure.
WIRING NOTE:
RED = LOW
BLACK = HIGH
WHITE = COMMON
GREEN = GROUND
17
