Water chemistry maintenance information will be provided by your installer. Care
should be taken to properly sanitize the water and balance the ph. Poor water
conditions can cause permanent damage to heaters and pumps, that may void your
warranty. Consult a local pool and spa professional for water treatment.
Filters and strainer baskets should be inspected and cleaned frequently, so it does not
effect water ow and operation.
Plumbing when starting systems, after relling, inspections are a good idea to nd
leaks in seals, valves, connections etc.
GFCI breakers should be tested monthly by following the manufacturer's steps for test
and reset.
Equipment area should be kept clean, not allowing snow, leaves or other moisture
holding material to buildup
Electrical connections should be inspected and tightened by a certied electrician
every few years. This includes bonding wires, conductors, breakers and terminal strip
connections
When servicing the lters or replacing the water, power OFF the system at the GFCI or
disconnect. Once service is complete, follow the startup procedures in this manual.
Systems equipped with Plus Ozone should have the removable lter checked and
™
cleaned annually. Additionally the ozone plumbing check valve should be tested for
operation. Reference the Plus Ozone plumbing connection page for location and
™
instruction.
REQUIRED MAINTENANCE
WATER TEMPERATURES HIGHER THAN SET TEMPERATURE
In warmer months, running the pump in prolonged timing cycles will add heat
kinetically to the water. Shorten lter times in summer to prevent heat gain.
* NOTE that frequently in warmer months; expect spa/hot tub water to settle just
below ambient air temps. During these months it's impossible to set a temperature
on the spaside below the natural water temp. For this reason, you can experience
water temps above your desired set temperature.
TROUBLESHOOTING
41