HydroQuip 8800 BP Series, Installation & Operation Manual

Page: 37 / 52

Sets Filter 1 length in hours
Sets start hour
Selects part of an hour
SET FLTR1 P SET FLTR1 P SET FLTR1 P
Sets 15-minute increments
SET FLTR 1 P
FLTR 1 FLTR 1 SET FLTR 1 SET FLTR 1 SET FLTR1
Shows/ashes start time
FLTR1
to show RUN HRS
to show F1 ENDS xx:xx
Sets 15-minute increments
A
1
While the Temperature is
still ashing, press Light
repeatedly until FLTR 1
appears in the LCD.
SET RANGE
Main Screen
READY RANGE FLTR1
Main Screen
READY RANGE FLTR1
Sets Filter 1 length in hours
Sets start hour Selects minutes
Selects part of an hour
SET FLTR 2 P SET FLTR 2 P SET FLTR 2 P
Sets 15-minute increments
SET FLTR 2 P
FLTR 2 FLTR 2 SET FLTR 2 SET FLTR 2 SET FLTR 2
Shows/ashes start time
FLTR2
to show RUN HRS
to show F1 ENDS xx:xx
Sets 15-minute increments
A
Main Screen
READY RANGE FLTR1
2
To next item in
Main Menu
Main Screen
READY RANGE FLTR1
SET FLTR 2 SET FLTR 2
To Set
To Set
To Set
To Set
To Set
Waiting
Several Seconds
Reverts to Original Setting
Waiting
Several Seconds
Reverts to Original Setting
Wait to
*****
Revert
Waiting Several Seconds
Waiting several seconds
will lose any new Filter 1
Start Time and Run Hours and
*****
revert to the previous Filter 1 settings.
To Set
Waiting several seconds
will lose any new Filter 2 On/OFF,
Start Time and Run Hours and
revert to any previous Filter 2 settings.
*****
Wait to
Revert
*****
Main Filtration
Filter cycles are set using a start time and a duration. Start time is indicated by an “A” (AM) or “P” (PM) in the bottom right
corner of the display. Duration has no “A” or “P” indication. Each setting can be adjusted in 15-minute increments. The
panel calculates the end time and displays it automatically.
Filter Cycle 2 - Optional Filtration
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten
overall ltration by the overlap amount.
purge water from their respective plumbing by running briey at the
beginning of each lter cycle.
If Filter Cycle 1 is set for 24 hours, enabling Filter Cycle 2 will initiate a purge
when Filter Cycle 2 is programmed to begin.
Selects minutes
*****
Reverts to Original Setting
*****
FILTER SETTINGS
2. In Rest Mode, heating only occurs during the lter cycle
3. Purges happen at the start of each lter cycle
* For example, if your spa is set up for 24/hour circulation except for shutting
off when the water temperature is 3˚F/1.3˚C above the set temperature, that
shutoff does not occur during lter cycles.
1. The heating pump always runs during the lter cycle*
The Meaning of Filter Cycles
In order to maintain sanitary conditions, secondary Pumps and/or a Blower will
Purge Cycles
32
Filter Cycle 2 is OFF by default.