Hydronix Hydro-Control VI, Operator'S Manual

Page: 53 / 88

Chapter 8 Using Moisture Control
Hydro-Control VI Operators Guide HD0456 Rev 1.7.1 53
Figure 28 shows the 2-Step Water Addition calibration points that are taken from the cycle
shown in Figure 27. The line from point A to point C is used for the water calculation when in
CALC Mode. The moisture value shown before admixture addition is based on the A to B line
and after the admixture addition the B to C line is used.
Moisture
Unscaled
A
B
C
Figure 28: The calibration lines from the 2-step preset mode cycle
4.2
Setting up the 2-Step Water Addition
This procedure requires that you have already set up the basic recipe as per Chapter 7.
Task Action
Press the Menu button.
Press
Press the Recipe Overview button.
Press
Select the recipe to set up and then press the Edit Recipe
button.
Press
On Page 1, in the Water Addition section, select the box ‘2
Step Addition.’
On Page 2 go to the Admix Settings and set the Admix
Enable to the point in the main water addition that you require
the admixtures to be introduced. If required the amount of
Admixture can be entered here and will be reported in the Mix
Log.
Save the recipe changes, then press menu and then
overview to return to the Overview Screen
Press