Hydronix Hydro-Control VI, Operator'S Manual

Page: 12 / 88

Introduction Chapter 1
12 Hydro-Control VI Operators Guide HD0456 Rev 1.7.1
2 About this Manual
This manual has been designed to act as a reference guide for an operator, describing the basic
recipe design and setup, and goes on to more advanced techniques such as fine tuning the
moisture control modes.
This manual complements the Installation Guide which details the installation, all the system
parameters and initial setup of the Hydro-Control VI.
The manual is divided into chapters which cover setting up recipes in and using the Hydro-Control
VI to make concrete.
Hydro-Control VI
navigation
Designing the mix
cycle
Setting up a recipe
Running the first
mix
Using moisture
control to
automatically add
water
Chapter 2 describes how to navigate around the Hydro-Control VI and
introduces the system
Chapter 4 introduces the mix cycle and Chapter 5 explains the
difference between the water addition modes.
Chapter 6 describes the recipe editor and how to edit the parameters
to get the desired result.
Chapter 7 shows how to run the first mix and tune the basic preset
water addition mode.
Chapter 8 explains how to calibrate the system and start using
moisture control for automatic addition of the water into the mixer.