HUSTLER SmoothTrak Super S, Manual, Page: 132 / 432

REV A 3-6 606834CE
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV
Operating Suggestions
Inexperienced operators may have a tendency to oversteer
and lose control. Practice slow maneuvers at low engine rpm
(idle) on a flat open area before attempting normal speed
operation.
When turning on soft wet turf, keep both wheels rolling
either forward or backward. Pivoting on one stopped wheel
can damage turf, especially when mowing.
Set the throttle at full rpm for maximum performance. This
gives maximum power to the drive wheels and deck when
needed. The throttle setting directly controls blade speed.
Use the control levers to control ground speed rather than
engine rpm.
Keep blades sharp. Many problems with incorrect cutting
patterns are due to dull blades or blades which have been
sharpened incorrectly. Information on sharpening blades is
listed in this manual’s maintenance section. Blade sharpness
should be checked daily.
Figure 3-9
Step 1
THREE POINT TURN
Step 2
Step 3
Right
control
lever
Left
control
lever
Neutral
Right
control lever
Left
control lever
Neutral
Neutral
Left control lever
Right control lever
An inexperienced operator should not operate on
slopes or on uneven terrain.
Before attempting normal speed operation an
inexperienced operator should:
• be thoroughly familiar with the proper use
and operation of the equipment.
• read the manual completely and thoroughly.
• have attempted slow moving maneuvers.
If you lose steering control while operating the
mower, turn the engine off and, if on a slope, step off
of the operator’s platform to the uphill side. Inspect
the machine and involve your Hustler
®
Dealer to
resolve the problem before continuing to operate.
The unit’s steering control levers are very
responsive: Easy does it! For smooth operation,
move the levers slowly, avoiding sudden
movement. Skill and ease of operation come with
practice and experience. The machine can spin
very rapidly. Use caution when making turns and
slow down before making sharp turns.
Sharp depressions or raised obstacles (such as
gutters or curbs) should not be directly
approached at high speed in an attempt to “jump”
them as the operator could be thrown from the
equipment. Disengage the deck clutch and raise
the deck to the transport position. Approach at a
slow speed and angle one drive wheel at the
obstruction. Continue at an angle until the wheel
clears and then pivot the opposite wheel around.
DANGER
WARNING
WARNING
WARNING