Hussmann Ingersoll Rand, User Manual

Page: 315 / 346

Hussmann Aftermarket 1/13/06 Page 7 of 19
7. Place the amount of spacer washers provided with original 3D compressor over
the existing mounting holes. (See Figure 10a.)
NOTE: When installing 4 bolt IR Impact
™
to a 4 bolt Copeland suction adapter
kit, place two additional ½” washers (G) under each leg to raise the
compressor for alignment to the suction valve.
Attach rails to frame with original compressor mounting bolts through the spacer
washers to the frame using the original compressor bolts provided,
(See Figure 10b).
Rail (A)- marked (Left Front) mounts to left side with the relief facing down.
Rail (B)- marked (Right Front) mounts to right side with the relief facing down
.
L Down R Down
Figure 11
8. Place compressor on rails and secure with
the 1/2”-13 x 1 1/2” bolt (C) and1/2”
washers (G).
Figure 9
6. Install discharge goose neck (F) using
gasket (J) to compressor discharge
flange with the original discharge valve
bolts.
Figure 10a.
Figure 10b
.