H.39
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
5
6
7
H02248
8
10
9
H11052
11
12
11
12a
7
H11053
ENGINE REASSEMBLY
Workshop Manual Ed. 07-2012
Refit the rotor (5). Hold the rotor (5) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (6) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
Before installing the starter motor (7), check for free (clockwise) rotation of the
freewheel (4) while holding the rotor (5) steady.
Assemble the starter motor (7).
On assembly, check the gasket (8) for damage and replace it if
needed. Make sure to position it correctly with the gasket hole (9)
matching the hole (10) in the starter motor flange.
Fit the starter motor (7) into place.
Tighten the bevel drive screws (11) using a 4 mm Allen wrench (6 Nm - 0.6Kgm
- 4.43 ft/lb).
Tighten the screws (12) (12a) using a 4 mm Allen wrench (6 Nm - 0.6Kgm - 4.43
ft/lb).
12=L= 25 mm
12a=L=30 mm