©
2012 by Huchez Treuils S.A.S.
Translation of the original instructions manual
31
EN
Reproduction prohibited
D
– Optional equipment
End limit switches
Easy to adjust, this system guarantees safety by preventing upper and lower overruns.
Second rope clamp
Allows you to lift a load using several ropes or facilitates a two-way system.
Rope slack switch
This automatically stops the winch when the rope is not taut (for example during
descent when an obstacle is blocking the load).
If the rope output angle is changed, the positioning of the electrical contact can be
adjusted by turning the screw.
Grooved drum
Facilitates correct winding of the rope on the first layer. Essential when installing a
two-way system.
Electronic load limiter
With CROUZET limiter
The winch is adjusted in the factory with the electrical voltage indicated on the test report enclosed with this
instruction manual. If this voltage is different in the place of use, the setting must be readjusted.
In the event of overloading of the winch, a load limitation by motor current measurement cuts the lift control.
Once you have identified and eliminated the cause of the load limiter activation, use the key-activated turning button
on the right of the unit to reset the load limiter and use the winch again.
Adjust the sensitivity of the load limiter by adjusting the "
I value
" on the limiter using a small flat screwdriver:
the load limiter is adjusted in the factory to the value of about 110% of its MCU.