©
2012 by Huchez Treuils S.A.S.
Translation of the original instructions manual
18
EN
Reproduction prohibited
Principle of reeving:
8.5.5. Adjusting the limit switch
1. Open the limit switch by loosening the screws (1).
2. Set the trigger point for the cams; to set them properly, loosen the central screw (12) from the group of cams, set
the trigger point for each cam using their adjustment screws (11) (the screws are numbered to indicate the cams in
increasing order from the bottom of the group to the top), then tighten the central screw (12).
3. Close the limit switch using the metric screws (1).
If the limit switch is equipped with a safety cable, insert the free end of the no-drop cable into a screw (2). Ensure
the rubber seal of the cover is in the correct position and tighten the screws (1) using an 80/100 N·cm tightening
torque.
