Huber Pilot ONE Unistat T300 Series, Operation Manual

Page: 85 / 90

Shutting down
Chapter 8 OPERATION MANUAL
V1.2.0en/12.05.15//14.06
Liability for errors and misprints excluded. Unistat® T300 Series
85
8 Shutting down
8.1 Safety instructions and basic principles
Connection/adjustment to the power supply not carried out by an electrician and/or connection
to a power socket without protective earth (PE)
MORTAL DANGER FROM ELECTRIC SHOCK

Have the connection/adjustment to the power supply carried out by an electrician.
 Always connect the temperature control unit to safety sockets (PE).
Damaged power cable/power cable connection
MORTAL DANGER FROM ELECTRIC SHOCK

Do not start up the temperature control unit.

Isolate the temperature control unit from the power supply.

Have the power supply cable/power supply connection replaced and inspected by an electri-
cian.

Do not use a power cable that is longer than 3 m .
Risk of tipping due to unstable temperature control unit
SERIOUS INJURY AND PROPERTY DAMAGE
 Avoid risk of tipping due to unstable temperature control unit.
Non-compliance with the safety data sheet for the thermal fluid to be used
INJURIES

Risk of injury to the eyes, skin, respiratory tract.

The safety data sheet for the thermal fluid to be used must be read prior to use and its con-
tents respected.

Observe the local regulations/work instructions.

Wear your personnel protective equipment (e.g. temperature-resistant safety gloves, safety
goggles, safety footwear).

Danger of slipping through contamination of floor and work area.
Hot or very cold thermal fluid
SERIOUS BURNS/FREEZING OF LIMBS
 Before draining, ensure that the thermal fluid has room temperature (20 °C).

If, at this temperature, the thermal fluid is too viscous to be drained: Control the temperature
of the thermal fluid for a few minutes until the viscosity will allow drainage. Never control the
temperature of the thermal fluid when the
>Drain valve<
[4] is open.

>Drain valve< [4] is closed by turning it clockwise (turn 90° right as far as it will go).
 Danger of burns when draining thermal fluids at temperatures above 20 °C.
 Wear your personal protective equipment when carrying out the drainage operation.

Only drain with a suitable draining hose and container (these must be resistant to the thermal
fluid and temperature).
All safety instructions are important and must be followed accordingly during working operations!