Huber Pilot ONE Unistat T300 Series, Operation Manual

Page: 77 / 90

Service/maintenance
Chapter 7 OPERATION MANUAL
V1.2.0en/12.05.15//14.06
Liability for errors and misprints excluded. Unistat® T300 Series
77
7.2.2 Replacing the “Unistat® Control ONE”
PROCEDURE

Switch off the temperature control unit. Do this by turning the >Mains isolator< [36] to “0”!

Disconnect the temperature control unit from the current supply.

Remove the “Pilot ONE” (see page 76, section »Replacing the “Pilot ONE®”« ).

Undo the fastening screw on the “Unistat Control ONE”.

Also pull the “Unistat Control ONE” away upwards.

Carefully insert the replacement “Unistat Control ONE”.

Fasten the replacement “Unistat Control ONE” with the fastening screw.

Install the “Pilot ONE” (see page 76, section »Replacing the “Pilot ONE®”« ).

Connect the temperature control unit to the power supply.

Switch the temperature control unit on.
7.3 Maintenance
Cleaning/maintenance while the temperature control unit is operating
MORTAL DANGER FROM ELECTRIC SHOCK

Stop an ongoing temperature control process.

Disconnect the temperature control unit from the power supply by turning the >Mains isola-
tor< [36] on the temperature control unit to “0”.

Also disconnect the temperature control unit from the current supply.
Carrying out maintenance work not described in this operation manual
DAMAGE TO THE TEMPERATURE CONTROL UNIT

For maintenance work not described in the operation manual, contact Peter Huber
Kältemaschinenbau GmbH.

Maintenance work not described in this operation manual is reserved for qualified specialists
trained by Huber.

Only perform the following maintenance work on the temperature control unit yourself.
Replacing the “Unistat
Control ONE”