Run the ipmcget -d passwordcomplexity command to check whether the password
complexity check function is enabled, and ensure that the new password meets the
following requirements:
● If the password complexity check function is disabled, a password can be empty or a
string of up to 20 characters.
● If the password complexity check function is enabled, the password must meet the
following requirements:
● Must contain 8 to 20 characters.
● Must contain at least one space or one of the following special characters:
` ~ ! @ # $ % ^ & * ( ) - _ = + \ | [ { } ] ; : ' " , < . > / ?
● Must contain at least two types of the following characters: lowercase letters (a to z),
uppercase letters (A to Z), and digits (0 to 9).
● Cannot be the same as the user name or user name in reverse order.
----End
5.3.3 Configuring Basic HMM Data
Procedure
Step 1 Configure an HMM IP address.
NO TICE
After the IP address is configured, the new IP address takes effect immediately,
and you must use the new IP address to log in again.
1. Log in to the HMM CLI. For details, see
5.3.1 Logging In to the HMM CLI
2. On the HMM CLI, run one of the following commands:
–
Setting an IPv4 address: ipmcset -d ipaddr -v <
ipaddr
> <
mask
>
[
gateway
]
–
Setting an IPv6 address: ipmcset -d ipaddr6 -v <
ipaddr6
/
prefixlen
>
[
gateway6
]
describes the parameters in the ipaddr and ipaddr6 command.
Table 5-2 Parameter description
Parameter
Description
Value
ipaddr
Specifies the IPv4
address of the network
port to be configured.
The value of this parameter is in
the data type of IPv4 and in the
format of
xxx.xxx.xxx.xxx.
mask
Specifies the subnet
mask of the network
port to be configured.
The value of this parameter is in
the data type of IPv4 and in the
format of
xxx.xxx.xxx.xxx.
TaiShan X6000 Server
User Guide
5 Configuring the X6000
Issue 04 (2020-06-05)
Copyright © Huawei Technologies Co., Ltd.
67
