Racing Kit
2-30
Drive Chain Guard Installation
The inside of the swingarm is filled with urethane foam. Do not weld the drive
chain guard because the urethane foam will burn.
1. Remove the swingarm. Drill ø9.05 - 9.25 mm holes for the pop nut as shown.
Apply
adhesive
Pop nut, 6 mm
(manufactured by POP RIVET FASTENER LTD.; SPH650R or equivalent)
Stake
Washers
(racing kit)
Drive chain guard
(racing kit)
Bolt/washers
(racing kit)
2. Apply adhesive to the drill holes and pop nut seat, and install the pop nuts
into the holes. Stake the pop nut using a commercially available tool.
3. After the adhesive hardens, install the washer and drive chain guard and
tighten the bolt/washers securely.
