HP ZBook Fury 17 G7, Maintenance And Service Manual, Page: 63 / 232

4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Solid-state drive 2
To remove solid-state drive 2, use this procedure and illustration.
Table 5-7 Solid-state drive description and part number
Description Spare part number
Only NVMe solid-state drives can be used in solid-state drive compartment 2.
1 TB, M.2 2280, PCIe, NVMe-3×4, SS with TLC L85348-001
512 GB, M.2 2280, PCIe, NVMe, SED with TLC L85368-002
256 GB, M.2 2280, PCIe, NVMe, SED with TLC M07245-001
Before removing solid-state drive 2, follow these steps:
1. Prepare the computer for disassembly ( Preparation for disassembly on page 66 ).
2. Remove the service cover ( Service cover on page 40 ).
3. Remove the battery (see Battery on page 41 ).
Remove solid-state drive 2:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive cover to the computer.
2. Lift the right side of the cover (2) until it rests at an angle.
ENWW Component replacement procedures 49