HP Xw6200 - Workstation - 2 GB RAM, Technical Reference Manual

Page: 52 / 209

52
SYSTEM MANAGEMENT
4 Before exiting, select File>Save Changes and Exit .
ESTABLISHING A POWER-ON PASSWORD USING WORKSTATION SETUP
Establishing a power-on password through Computer Setup prevents access to the workstation when
power is turned on, unless the password is entered. When a power-on password is set, Computer Setup
presents Password Options under the Security menu. The password options include Network Server
Mode and Password Prompt on Warm Boot.
When Network Server Mode is disabled, the password must be entered each time the workstation is
turned on when the key icon appears on the monitor. When Password Prompt on Warm Boot is enabled,
the password must also be entered each time the workstation is rebooted. When Network Server Mode
is enabled, the password prompt is not presented during POST, but any attached PS/2 keyboard will
remain locked until the user enters the power-on password.
To establish a power-on password through workstation setup:
1 Turn on or restart the workstation. If you are in Windows, click Start>Shut Down>Restart .
2 As soon as the computer is turned on, press and hold the F10 until you enter Computer Setup. Press
Enter to bypass the title screen, if necessary.
NOTE If you do not press the F10 key at the appropriate time, you must restart the workstation and
press and hold the F10 key again to access the utility.
If you are using a PS/2 keyboard, you may see a Keyboard Error message—disregard it.
3 Select Security>Power-On Password and follow the on-screen instructions.
4 Before exiting, select File>Save Changes and Exit .
ENTERING A POWER-ON PASSWORD
To enter a power-on password:
1 Turn on or restart the workstation. If you are in Windows, click Start>Shut Down>Restart the
Computer .
2 When the key icon appears on the monitor, enter the current password, then press Enter .
NOTE Type carefully. For security reasons, the characters you enter do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three unsuccessful
tries, you must turn off the workstation, then turn it on again before you can continue.
ENTERING A SETUP PASSWORD
If a setup password has been established on the workstation, you will be prompted to enter it each time
you run Computer Setup.
To enter a setup password:
1 Turn on or restart the workstation. If you are in Windows, click Start>Shut Down>Restart the
Computer .