HP StorageWorks 1510i - Modular Smart Array, User Manual, Page: 62 / 160

Clean-up con fi guration tasks
After initially con fi guring the host and MSA, to complete the con fi guration, be sure to:
• Check the SMU to ensure that all initiators have been added.
• Verify in the initiator software that the 1510i targets are present.
• Logon to the available targets.
• Ensure that the connection is automatically restored when the system boots.
• Set up security measures (ACLs, VLANS, and CHAP).
• In active/active multipath environments, distribute ownership of the LUNs between the two MSA
controllers. Choose one of the following:
• Automatic (also called implicit) load balancing (default)—MSA
fi rmware automatically
reassigns LUN ownership evenly between the controllers based on I/O loads of the LUNs.
(Recommended)
• Manual (also called explicit) load balancing—Through the SMU or the CLI, indicate the
preferred path (controller ownership) for each LUN.
Con fi guring the Microsoft iSCSI initiator
IMPORTANT:
When installing the multipathing components, be sure to install Both the DSM and the MPIO core
components.
If you are unfamiliar with the con fi guration and use of Microsoft’s iSCSI initiator software, this section
describes how to con fi gure the Microsoft iSCSI initiator to connect to a dual-controller MSA1510i in a
multipathing environment. (For single-controller con fi gurations, omit all steps shown for multipath or
dual-controller con fi gurations.)
For more information, see the iSCSI initiator user documents or online help.
IMPORTANT:
When installing the iSCSI initiator, grant use of the initiator to
Everyone
.
1. Open the iSCSI initiator.
The iSCSI Initiator Properties window is displayed.
62
Con fi guration