Hardware options installation 92
Mirrored memory configuration
Mirroring provides protection against uncorrected memory errors that would otherwise result in server
downtime. Mirroring is performed at the channel level. Channels 1 and 2 are used; channel 3 is not
populated.
Data is written to both memory channels. Data is read from one of the two memory channels. If an
uncorrectable error is detected in the active memory channel, data is retrieved from the mirror channel. This
channel becomes the new active channel, and the system disables the channel with the failed DIMM.
General DIMM slot population guidelines
Observe the following guidelines for all AMP modes:
•
Install DIMMs only if the corresponding processor is installed.
•
When two processors are installed, balance the DIMMs across the two processors.
•
White DIMM slots denote the first slot of a channel (Ch 1-A, Ch 2-B, Ch 3-C, Ch 4-D)
•
Do not mix RDIMMs and LRDIMMs.
•
When one processor is installed, install DIMMs in sequential alphabetic order: A, B, C, D, E, F, and so
forth.
•
When two processors are installed, install the DIMMs in sequential alphabetic order balanced between
the two processors: P1-A, P2-A, P1-B, P2-B, P1-C, P2-C, and so forth.
•
When single-rank, dual-rank, and quad-rank DIMMs are populated for two DIMMs per channel or three
DIMMs per channel, always populate the higher number rank DIMM first (starting from the farthest slot).
For example, first quad-rank DIMM, then dual-rank DIMM, and then lastly single-rank DIMM.
•
DIMMs should be populated starting farthest from the processor on each channel.
•
For DIMM spare replacement, install the DIMMs per slot number as instructed by the system software.
For more information about server memory, see the HP website (
http://www.hp.com/go/memory
).
DIMM speeds are supported as indicated in the following table.
Populated slots
(per channel)
Rank
Speeds supported (MT/s)
1
Single-, dual-, or
quad-rank
2133
2
Single- or dual-rank
2133
2
Quad-rank
2133
3
Single-, dual-, or
quad-rank
1600
Depending on the processor model, the number of DIMMs installed, and whether LRDIMMs or RDIMMs are
installed, the memory clock speed can be reduced to 1600 MT/s.
Advanced ECC population guidelines
For Advanced ECC mode configurations, observe the following guidelines:
•
Observe the general DIMM slot population guidelines (on page
92
).
•
DIMMs may be installed individually.
Summary of Contents for ProLiant ML350 Gen9
