Removal and replacement procedures 39
3.
If replacing a hot-plug drive, remove the hot-plug drive to be replaced:
a.
Push in the thumb release of the desired hard drive carrier (Figure 3-13, 1).
b.
Pull the cam latch upward (Figure 3-13, 2).
c.
Gently pull the hard drive carrier straight out from the drive bay (Figure 3-13, 3).
Figure 3-13
Removing a hot-plug hard drive
4.
Slide the hot-plug HDD drive into the drive bay until resistance is felt (Figure 3-14, 1).
5.
Verify that the hooks behind the pivot end of the cam latch will engage the hole on the edge of
the hard drive cage.
6.
Rotate the cam latch down to fully seat the drive carrier into the backplane and press in until it
clicks into place (Figure 3-14, 2).
Figure 3-14
Installing a hot-plug hard drive
7.
Replace and close the front bezel.
End of procedure.
All manuals and user guides at all-guides.com
Summary of Contents for ProLiant ML150 G6
Page 12: ...Customer self repair 12 All manuals and user guides at all guides com ...
Page 13: ...Customer self repair 13 All manuals and user guides at all guides com ...
Page 14: ...Customer self repair 14 All manuals and user guides at all guides com ...
Page 15: ...Customer self repair 15 All manuals and user guides at all guides com ...
