Removal and replacement procedures 53
•
Supported DIMM capacities: 1 GB, 2 GB, 4 GB DDR3 registered DIMM and 1 GB, 2 GB, 4 GB
un-buffered DIMM.
•
Supported technologies: 1 GB, 2 GB, 4 GB x12 devices for registered and 1 GB, 2 GB, 4 GB x
12 devices for un-buffered.
•
For best performance, DIMMs should be installed in symmetrical (balance-capacity) pairs.
Table 3-2
DIMM slot Configurations
1D
2A
3E
4B
5F
6C
–
•
–
–
–
–
–
•
–
•
–
–
–
•
–
•
–
•
•
•
–
•
–
•
•
•
•
•
–
•
•
•
•
•
•
•
– : Empty
•: DIMM
installed
To remove a memory module:
1.
Power down the server.
2.
Disconnect the power cord(s).
3.
Unlock the server if necessary and remove the access panel as described in the section “System
covers.”
4.
Remove the air baffle by pulling up slightly on the four tabs and lifting the baffle away from the
chassis.
5.
Remove the hard drive fan holder if needed.
6.
Completely open the holding clips securing the module (Figure 3-32, 1).
7.
Gently pull the memory module upward to remove it from the slot (Figure 3-32, 2).
Figure 3-32
Removing a memory module (DIMM)
All manuals and user guides at all-guides.com
Summary of Contents for ProLiant ML150 G6
Page 12: ...Customer self repair 12 All manuals and user guides at all guides com ...
Page 13: ...Customer self repair 13 All manuals and user guides at all guides com ...
Page 14: ...Customer self repair 14 All manuals and user guides at all guides com ...
Page 15: ...Customer self repair 15 All manuals and user guides at all guides com ...
