Removal and replacement procedures 36
Hard drives
The server uses an HDD cage assembly that supports four hard drives in either a non-hot-plug or hot-
plug configuration. The server supports SATA or SAS hard drives. SATA hard drives are supported
directly by the system board. SAS hard drives require an SATA/SAS PCIe expansion card. For more
information about installing PCIe expansion cards, see “Expansion cards.”
Non-hot-plug hard drives
Servers shipped in a non-hot-plug drive configuration include a non-hot-plug HDD cage installed in the
upper bay area (bays 1 through 4).
Removing/replacing a non-hot-plug hard drive
To remove and replace a non-hot-plug hard drive:
1.
Power down the server.
2.
Disconnect the power cord(s).
3.
Remove the access panel and front bezel as described in the section titled “System covers.”
4.
Disconnect the power and data cables from all hard drives (Figure 3-9, 1).
5.
Remove the four mounting screws from the HDD cage (Figure 3-9, 2) and slide the HDD cage out
from the server chassis (Figure 3-9, 3).
Figure 3-9
Removing a non-hot-plug HDD cage
All manuals and user guides at all-guides.com
all-guides.com
Summary of Contents for ProLiant ML150 G6
Page 12: ...Customer self repair 12 All manuals and user guides at all guides com ...
Page 13: ...Customer self repair 13 All manuals and user guides at all guides com ...
Page 14: ...Customer self repair 14 All manuals and user guides at all guides com ...
Page 15: ...Customer self repair 15 All manuals and user guides at all guides com ...
