System Configuration
c. Remove the six Torx screws that secure the cage to the chassis.
Keep the screws for reinstalling the cage later.
d. Gently slide out the cage from the chassis.
e. If you are going to install the new hard disk in a drive bay that is previously empty,
remove four screws from the side of the chassis labeled ‘HDD SCREWS’.
Figure 4-11: Removing the HDD cage
5. Select a drive bay in the HDD cage where you want to install the new hard disk.
If necessary, pull out any previously installed drive by removing the four screws securing
the old drive to the cage, before sliding the drive out of the cage. You will be reusing
these screws when you install the new hard disk.
6. Install the new hard disk:
a. Slide the new hard disk into the selected bay.
b. If you are installing the new hard disk in a drive bay that is previously empty, use the
four screws you removed earlier from the side of the cage (step 4-e) to secure the
new drive.
If you are installing the new hard disk in a drive bay where there was a previously
installed drive, use the screws you removed from that old drive to secure the new
drive.
HP ProLiant ML110 Server Operations and Maintenance Guide
4-13
