System Configuration
Figure 4-20: Removing a DIMM
7. Place the DIMM on a static-dissipating work surface or inside an anti-static bag.
To Install a DIMM
1. Locate an empty DIMM slot on the mainboard.
2. Remove a DIMM from its protective container, handling the module by its edges.
If necessary, lay it on an anti-static surface until you are ready to install it.
3. Install the DIMM:
a. Orient the DIMM so that the notch on its bottom edge aligns with the keyed surface
of the DIMM slot, then press the DIMM fully into the slot.
The DIMM slots are structured to ensure proper installation. If you insert a DIMM
but it does not fit easily into the slot, you may have inserted it incorrectly. Reverse
the orientation of the DIMM and insert it again.
b. Firmly press the holding clips inward to secure the DIMM in place.
If the holding clips do not close, the DIMM is not inserted correctly.
Figure 4-21: Installing a DIMM
4. Observe the post-installation procedures.
HP ProLiant ML110 Server Operations and Maintenance Guide
4-21
