System Configuration
Figure 4-23: Installing a PCI card
7. Observe the post-installation procedures.
Battery
Your HP ProLiant server is equipped with a 3V 200 mAh internal lithium battery.
To Replace the Battery
WARNING: Note the following reminders when replacing the battery.
•
Replace the battery with the same type as the product's battery we recommend.
Use of another battery may present a risk of fire or explosion.
•
Batteries may explode if not handled properly. Do not disassemble or dispose of
them in fire. Keep them away from children and dispose of used batteries
promptly. Dispose of used batteries according to manufacturer's instructions.
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Lay the server on its side (components showing) for better access to the battery socket.
4. If necessary, remove any accessory boards or SCSI cables that prevent access to the
battery socket.
5. Replace the battery:
a. Insert a small flat-blade screwdriver or a similar tool between the battery and spring
latch to dislodge the battery from its socket.
b. Lift up the battery to remove it.
HP ProLiant ML110 Server Operations and Maintenance Guide
4-23