System Configuration
PCI Cards
The HP ProLiant ML110 server supports five PCI bus slots with two separate bus channels:
•
•
Two 32-bit/33 MHz 5V PCI bus slots (PCI1 and PCI5)
Three 64-bit/66 MHz 3.3V PCI-X bus slots (PCI2 to PCI4)
To Install a PCI Card
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. If necessary, remove any accessory boards or cables that prevent access to the PCI slots.
4. Locate an empty PCI slot on the mainboard.
5. Remove the PCI card from its protective packaging.
If necessary, lay it on an anti-static surface until you are ready to install it.
6. Install the PCI card:
a. Press the retention clip of the slot cover opposite the selected PCI slot.
b. Pull out the slot cover. Keep it for reassembly later.
Figure 4-22: Removing a PCI slot cover
c. Slide the PCI card into the selected slot and press it down to seat it properly.
d. Firmly press the retention clip until it snaps into place.
e. Connect the necessary cable to the card.
4-22
HP ProLiant ML110 Server Operations and Maintenance Guide
