System Configuration
4-30
HP ProLiant ML110 Server Operations and Maintenance Guide
•
•
•
5. Select a configuration option by pressing the corresponding item number.
Tape-based One Button Disaster Recovery (OBDR)
Select this option to perform recovery procedures for a SCSI drive that supports
OBDR function.
Multi-initiator Configuration
Select this option to perform initial setup SCSI configuration.
Exit
Select this option to close the utility. System will automatically reboot.
OBDR Function
a. Press
1
to select the OBDR option.
The utility will scan your server for any installed SCSI tapes and display the results.
A message prompt will be shown below the scan results.
<<<Please choose the NUM of the tape drive
to place into OBDR mode>>>
b. Type the NUM value corresponding to the SCSI tape you want to place into OBDR
mode.
Auto-configuration will be initialized after which the system will automatically
reboot.
Multi-initiator Configuration
a. Press
2
to select the Multi-initiator Configuration option.
The utility will scan your server for any installed SCSI cards and display the results.
A message prompt will be shown below the scan results.
Enter choice (y/Exit x)
where
y
is the card number.
b. Enter the number for the card you want to configure.
You will be prompted to change the card ID.
c. Enter the new card ID.
You will be prompted to confirm the status of the
Reset SCSI BUS at IC
Initialization
parameter.
By default, this parameter is enabled. Press
Y
to disable the parameter.
d. Press
x
to save the configuration settings and close the utility.
The system will automatically reboot.
