HP ProLiant DL140, Maintenance And Service Manual

Page: 86 / 112

Contents 86
Front panel board cable connections
Figure 63
Front panel board cable connections
Item Connector Cable
1 CN2 Front panel board system
board connector
Connects to FPCN1 on the
system board
2 CN1 Front panel board power
connector
Connects to the PSU.
3 CN3 to CN6 4-pin system fan
connectors
Connects to the system
fans 1 to 4.
To route the front panel board cables:
CAUTION: Route the front panel board cables neatly. If necessary, secure them using the pre-
installed cable clips located on the chassis base. The cables should be routed in a position where
they will not be pinched or crimped by the top cover, nor should they hamper proper airflow inside
the chassis.
NOTE: NOTE: For ease of reading, front panel board will be simply referred to as “FPB” in the
following procedures.
1. Perform the pre-installation procedure described on page 29.
2. Remove the PCI riser board assembly.
3. Connect the FPB system board cable to the FPCN1 connector on the system board.
4. Route the FPB power and system board cables through the cable management opening of the
chassis’ partition wall.
5. Disconnect the drive and power cables of the available hard drives.
6. Route the FPB power and system board cables underneath the hard drive cables you
disconnected in the previous step.
All manuals and user guides at all-guides.com
all-guides.com