Contents 73
POST errors messages
Whenever a non-fatal error occurs during POST, an error message describing the problem appears
onscreen. These text messages are displayed in normal video (white text on black background). It
shows the details of the error. The following is an example of a POST error message:
Error message 1 of 1: Error code 0103
Keyboard not detected - Keyboard error
In some cases an error message may include recommendations for troubleshooting or require that you
press the
Enter
key to display recommendations. Follow the instructions on the screen.
Table 6 lists the most common POST error messages with their corresponding troubleshooting
recommendation. It is recommended that you correct the error before proceeding, even if the server
appears to boot successfully.
If your system displays one of the messages marked below with an asterisk (
*
), write down the code
and message and contact your HP Customer Support provider.
When no POST error message is displayed but the server stops during POST, listen for beep codes.
Table 6
POST error messages
Error code
Error message
Corrective action
0200
Failure Fixed Disk
Fixed disk is not working or not configured properly.
6
Run Setup and check if the fixed-disk type is correctly
identified.
7
Check to see if fixed disk is attached properly.
0210
Stuck key
Stuck key on keyboard.
8
Locate the stuck key on your keyboard and release it.
9
Reboot the server.
0211
Keyboard error
Keyboard not working.
Verify that the keyboard cable is securely connected to the
keyboard port (not the mouse port) on the rear panel of the
server.
If the problem persists, replace the keyboard or contact your HP
Customer Support provider.
0212
Keyboard Controller
Failed
Keyboard controller failed test.
0220
Monitor type does not
match CMOS - Run
SETUP
The attached monitor cannot be correctly identified by Setup.
Run Setup and check if the monitor type is correctly identified.
0250
System battery is dead
- Replace and run
SETUP
The CMOS clock battery indicator shows the system battery is
dead.
10
Replace the system battery following the procedures on
page 58
.
11
Run Setup to reconfigure the system.
All manuals and user guides at all-guides.com
Summary of Contents for ProLiant DL140
