HP ProLiant DL140, Maintenance And Service Manual

Page: 40 / 112

Contents 40
Configuring a hot-plug SATA/SAS hard drive
NOTE: The procedures below assume that the user is switching from a non-hot-plug SATA hard drive
system to a hot-plug SATA/SAS one.
The steps listed below give an overview of the hot-plug SATA/ SAS hard drive configuration
procedure.
1. Install the hot-plug backplane board.
2. Install the PCI-X riser board.
3.
Install the hot-plug SATA/SAS controller board.
4. Install the hot-plug cable.
5. Install the hot-plug SATA/SAS hard drive.
6. Set up the SATA/SAS configuration.
To install the hot-plug backplane board:
1. Perform the pre-installation procedure.
2. Remove the non-hot-plug HDD carriers and the non-hot-plug SATA data cables from the unit.
3. Rotate the blue T-locks on top of the HDD cage to the unlock position.
Figure 18 Unlocking the HPBB T-locks
4. Install the hot-plug backplane board (HPBB).
a.
Position the board, so that the connectors for the drive engagement are inside the drive
cage, and that
b.
The hooks on the rear of the drive cage engage with the slots in the board and that the
bottom of the board fits the bent tabs on the chassis base.
c.
Rotate the T-locks to the lock position to prevent the board from moving up.
All manuals and user guides at all-guides.com