HP ProLiant DL140, Maintenance And Service Manual

Page: 38 / 112

Contents 38
To remove a hot-plug SATA/SAS hard drive:
1. Make sure that the drive activity and fault identification LED indicators on the HDD carrier are
off.
2. Remove the hot-plug SATA/SAS hard drive from the chassis.
a.
Press the hard disk carrier button to release the ejector lever.
b.
Use the ejector lever to pull the drive out of the cage.
Make sure to support the drive when pulling it out of the cage.
Figure 14 Removing the hot-plug SATA/SAS hard drive from the chassis
3. Remove the hot-plug SATA/SAS hard drive from its carrier.
a.
Remove the four mounting screws that secure the hard drive to the carrier.
b.
Remove the hard drive from its carrier.
Figure 15
Removing the hot-plug SATA/SAS hard drive from its carrier
Configuring a non-hot-plug SATA hard drive
To install a non-hot-plug SATA hard drive:
NOTE: If you are switching from a hot-plug SAS hard drive system to a non-hot-plug SATA one, you
first need to remove the hot-plug backplane board, the hot-plug SATA/SAS controller board, and
the hot-plug cable. After that install the non-hot-plug SATA cable.
1. Perform the pre-installation procedure.
2. Select which drive bay you will use to install the new non-hot-plug SATA hard drive.
If the desired drive bay is occupied, remove the currently installed drive following the procedure
described on page 37.
If the desired drive bay is empty, slide the blank HDD carrier from the bay, and then remove four
mounting screws from it. You will use these screws to install the new drive.
All manuals and user guides at all-guides.com