Contents 26
Removal and replacement procedures
Required tools
In performing any hardware configuration procedure you may need the following tools:
•
T-15 Torx screwdriver
•
Flat-blade screwdriver
The following references and software tools may also be used:
•
HP ProLiant DL140 Generation 3 Server Support CD
•
IPMI Event Log
•
Diagnostics software
NOTE:
The figures used in this guide to illustrate procedural steps are labeled numerically (i.e., 1,
2…). When these figures are used in substep items, the alphabetically labeled instructions
correspond to the numbered labels on the related figure (i.e., Label 1 corresponds to step a, label 2
corresponds to step b, etc.).
Hardware configuration warnings
Read the following sections before performing any servicing or troubleshooting procedure.
WARNING:
Only authorized technicians trained by HP should attempt to repair this equipment.
Because of the complexity of the individual boards and subassemblies, no one should attempt to
make repairs at the component level or to make modifications to any printed wiring board.
Improper repairs can create a safety hazard.
CAUTION:
Whenever installing hardware or performing maintenance procedures requiring access
to internal components, it is recommended that all server data be backed up to avoid loss.
IMPORTANT:
Review the specifications of a new component before installing it to make sure it is
compatible with the server. When you integrate new components into the system, record its model
and serial number, and any other pertinent information for future reference. After completing any
removal or replacement procedure, run the diagnostics program to verify that all components
operate properly.
Server warnings and cautions
Before installing a server, be sure that you understand the following warnings and cautions.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
All manuals and user guides at all-guides.com
all-guides.com
Summary of Contents for ProLiant DL140
