HP P Class 733/800/866MHz / 1GHz, User Manual

Page: 76 / 158

60 Chapter 3
Troubleshooting Your HP Visualize Linux Workstation
If Your Workstation Does Not Start Properly
• Press to ignore the message and continue.
• Press to run Setup and correct a system configuration error. HP
recommends that you correct the error before proceeding, even if the
Workstation appears to start successfully.
• Press to accept (validate) the change and update Setup’s
configuration information.
• Press to see more details about the message. After viewing
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press to accept the change and update Setup’s
configuration information. Otherwise, press to ignore the
message and continue, or press to run Setup and correct a system
configuration error. (The number of choices you will have available
are dependent on the kind of error.)
Clearing the
Workstation’s
Configuration
Memory
If the Workstation then starts, but POST still persists in reporting an
error, clear the current configuration memory values and reinstall the
built-in default values:
1. Turn off the Workstation, disconnect the power and cables, and
remove the cover. Disconnect the Workstation from any
telecommunications network.
a. Set the system board switch 6 (CLEAR CMOS) DOWN to clear the
configuration.
b. Replace the cover, and reconnect only the power cable.