HP J3128A AdvanceStack 10Base-T Hub-8E, Manual

Page: 152 / 194

6-95
Configuration Reference
Config
uration Refe
ren
c
e
Figure 6-42. The Ping/Link Test Window Running a Ping Test
Running a Ping Test in the Browser Interface
To run a Ping Test from the Browser Interface, perform the following steps:
1. From the Tab Bar, click on the Diagnostics Tab. The Browser Interface
displays the Diagnostics Button Bar.
2. From the Diagnostics Button Bar, click the left mouse button the Ping/
Link Test button. The Browser Interface displays the Ping/Link Test
Window. Note that one of the top two radio buttons can be selected. If
this session is your first time in the Ping/Link Test Window for your HP
10Base-T Hub, the Ping Test radio button will be selected.
3. Decide whether you want to use the default values set up for either a Ping
or Link Test. If you do, click the left mouse button the Defaults Button
and go to Step 7. If not, go to the next step.
4. Click the left mouse button on the Ping Test radio button.
5. In the Destination IP/MAC Address box, type an IP Address. for example,
25.100.16.4
6. In the Number of Packets to Send box, use the list box to select a number,
either 1, 5, 10, or 20, to indicate the number packets the HP 10Base-T Hub
should send to the test device to determine whether a valid connection
exists between the two devices.
Note that the Ping Test
tests a path between
two devices, using an
IP Address.
Agent.bk : AGTCH6.FM5 Page 95 Thursday, February 19, 1998 2:13 PM