HP Compaq Presario,Presario 2140, User Manual

Page: 213 / 244

Information and Error Messages
213 Director Product Manager User Guide
Cannot start data
collection.
The data collection
procedure cannot be
started by the
Product
Manager
application
because the Ethernet
link is down or busy.
Retry the operation later. If the
condition persists, contact the
next level of support.
Cannot start firmware
install while CTP
synchronization is in
progress.
The director’s CTP
cards are
synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Install the firmware after CTP
card synchronization completes.
Cannot start port
diagnostics.
Port diagnostics cannot
be started at the
Product Manager
application because
the Ethernet link is
down or busy.
Retry the operation later. If the
condition persists, contact the
next level of support.
Cannot swap an
uninstalled port.
A port swap cannot be
performed when the
port card is not
installed.
Perform a swap only on a port
that is installed.
Click OK to remove all
contents from log.
This action deletes all
contents from the
selected log.
Click OK to delete the log
contents or click Cancel to
cancel the operation.
Connection to HAFM
server lost. Click OK to
exit application.
The
HAFM
application
at a remote
workstation lost the
network connection to
the HAFM server.
Start the
HAFM
application to
connect to the HAFM server.
Continuing may
overwrite host
programming.
Continue?
Configurations sent
from the host may be
overwritten by HAFM.
Continuing will activate the
current configuration, which
may have been configured by
an FICON host.
Could not export log to
file.
A log file I/O error
occurred and the file
could not be saved to
the specified
destination. The disk
may be full or write
protected.
Ensure file name and drive are
correct.
Table 9: Product Manager Messages (Continued)
Message Description Action