HP AA-RWF3A-TE, Installation Manual

Page: 17 / 159

4/8 and 4/16 SAN Switch chassis
This section describes the chassis front (port side) and rear (nonport side).
4/8 and 4/16 SAN Switch port side
All LEDs reside on the port side of the switch (see Figure 1 ). The 4/8 and 4/16 SAN
Switch enclosure uses forced-air cooling, with the fans pushing the air from the nonport
side of the chassis through the enclosure and exhausting at the port side.
See
Interpreting LED activity on page 69 for a complete description of switch LEDs.
scale: 5/16" = 1"
!
IOIOI 0
4
3
7
1
5
2
6
8
12
11
15
9
13
10
14
1 2 3 4
MRO25019a
1. AC power receptacle 3. Serial port
2. Ethernet port
4. FC ports (16)
Figure 1 4/8 and 4/16 SAN Switch port side
4/8 and 4/16 SAN Switch nonport side
The nonport side is used solely for airflow and serial number labels. There are two labels
on the rear of the chassis: one is the HP serial number, the other is the switch supplier’s
serial number. The left label also contains the 4/8 SAN Switch or 4/16 SAN Switch
MAC address and world wide name (WWN).
Activating additional 4/8 and 4/16 SAN Switch ports
The 4/16 SAN Switch models offer 8, 12, or 16 licensed ports. To enable ports
8 through 11, you must purchase and install one or more HP StorageWorks 4-Port
Upgrade Licenses . To enable ports 12 through 15, you must purchase and install a
second HP StorageWorks 4-Port Upgrade License .
To activate additional ports:
1. Use the
portshow
command to verify the number of ports licensed on your switch.
The port status output indicates
Started
and
Licensed
for enabled ports. See
the Fabric OS command reference manual for specific information on this command.
2. Use the
switchshow
command to obtain your SAN Switch WWN, which your HP
representative requires to assign a license key.
SAN Switch installation guide
17