■
-- Specify TFTP server IPv4 address. (IP-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
-- Specify TFTP server IPv6 address. (IPV6-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
-- Copy data to a USB flash drive.
■
-- Specify filename for the USB transfer. (ASCII-STR)
■
-- Use xmodem on the terminal as the data destination.
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
copy
< config1 | config2 | config3 > -- Copy named configuration file.
■
-- Copy data to specified configuration file. (ASCII-STR)
■
-- Copy data to a TFTP server.
■
-- Specify TFTP server IPv4 address. (IP-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
-- Specify TFTP server IPv6 address. (IPV6-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
-- Use xmodem on the terminal as the data destination.
■
-- Change CR/LF to PC style.
■
-- Change CR/LF to unix style.
■
copy
-- Copy the switch crash data file.
■
-- Enter single slot identifier. (SLOT-ID-RANGE)
■
-- Copy data to a TFTP server.
■
-- Specify TFTP server IPv4 address. (IP-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Specify TFTP server IPv6 address. (IPV6-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Copy data to a USB flash drive.
■
-- Specify filename for the USB transfer. (ASCII-STR)
■
-- Use xmodem on the terminal as the data destination.
■
-- Copy from the management card.
■
-- Copy data to a TFTP server.
■
-- Specify TFTP server IPv4 address. (IP-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Specify TFTP server IPv6 address. (IPV6-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Copy data to a USB flash drive.
■
-- Specify filename for the USB transfer. (ASCII-STR)
■
-- Use xmodem on the terminal as the data destination.
■
-- Copy data to a TFTP server.
■
-- Specify TFTP server IPv4 address. (IP-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Specify TFTP server IPv6 address. (IPV6-ADDR)
■
-- Specify filename for the TFTP transfer. (ASCII-STR)
■
-- Copy data to a USB flash drive.
■
-- Specify filename for the USB transfer. (ASCII-STR)
97
©
2009 Hewlett-Packard Development Company, L.P.
copy
Command Line Interface Reference Guide
Summary of Contents for 6200YL
Page 2: ......
Page 16: ...Introduction 14 2009 Hewlett Packard Development Company L P ...
Page 22: ...Commands 20 2009 Hewlett Packard Development Company L P ...
Page 764: ......