HP 6200YL, Reference Manual

Page: 94 / 765

console
OVERVIEW
Switch Management Category:
config Primary context:
show (page 511) Related Commands
repeat (page 470)
Usage: console ...
Description: Set various console parameters. Use 'console ?' to get a list
of all configurable parameters.
The non-configurable parameters and their default values are:
Data bits = 8; Parity = None; Stop bits = 1.
COMMAND STRUCTURE
■
console baud-rate < speed-sense | 1200 | 2400 | ... > -- Set the data transmission speed for the
device connect sessions initiated through the Console port (p. 93)
■
console events < None | Debug | All | ... > -- Set level of the events displayed in the device's Events
Log (p. 93)
■
console flow-control < XON/XOFF | None > -- Set the Flow Control Method; default is xon-xoff
(p. 93)
■
console inactivity-timer < 0 | 1 | 5 | ... > -- Set the number of minutes of no activity detected on
the Console port before the switch terminates a communication session (p. 94)
■
console local-terminal < VT100 | NONE | ANSI > -- Set type of terminal being used for the current
console or telnet session (default is vt100) (p. 94)
■
console screen-refresh < 1 | 3 | 5 | ... > -- Set default number of seconds before screen is refreshed
on the repeat command (p. 94)
■
console terminal < VT100 | NONE | ANSI > -- Set type of terminal being used for all console and
telnet sessions (default is vt100) (p. 95)
EXAMPLES
Example: console <...>
Configure the switch to use the following console settings:
■
VT100 operation
■
19,200 baud
■
No flow control
■
10-minute inactivity time
■
Critical log events
ProCurve(config)# console terminal vt100 baud-rate 19200 flow-control none
inactivity-timer 10 events
critical
Command will take effect after saving configuration and reboot.
92 © 2009 Hewlett-Packard Development Company, L.P.